Smeg 50's Retro style Guia de Resolução de Problemas

INSTALLATION & USER INSTRUCTIONSAll instructions must be handed to the user for safekeeping.Revision A - 08/07Country(s) of destination - GB/IEL30

All models : Firstly, remove the decorativeframe/glass facia assembly as described in section8.3. Remove the inner glass panel, and disconnect thegas

It is recommended that the catalysts are inspected for signs of damage and dirt during routine servicing procedures.The expect-ed life of the catalyst

Fire sparks but pilot does not light No gas to fire, check isolators are open.Pipe work blockage, clean out.Air not fully purged, re purge supply or w

Section Content Page No1.0 Important Notes 12.0 Clearances to Combustibles 13.0 Ventilation & Room Size 24.0 Operating Instructions 35.0 Combustio

Clearances to combustible materialsCombustible materials are defined as wood, fabrics, or other materials likely to combust if exposed to flame. Gener

Classic models : The control knob is located on thelower right hand side of the outer case.It is marked asshown in figure 6;Linear models : The contro

The appliance should be checked on an annual basis to ensure it is working safely and that there is no excessive build up of soot.The frequency of ser

L30 FabP23 LinearP23 ClassicL23 LinearL23 Classic© 2007 Smeg (UK) LTDPlease note : Except where otherwise stated, all rights,including copyright in th

This appliance is a high efficiency, flueless catalytic flame effect gas fire. It provides radiant and convected warmth both efficient-ly and safely u

If the appliance is to be sited near a disused or unserviceable fireplace served by a natural draught flue then the old flue must besealed off. It wil

The appliance is designed to be versatile, and as such will operate correctly when exposed to normal gentle draughts experiencedwithin the home. It is

Remove the outer packaging, remove any instructions or fixing kits.Read ALL these instructions before continuing to unpack or install this appliance.L

If the appliance is to be mounted on the inner leaf of a conventional cavity brick wall, or a solidwall, then the fibre wall plugs and fixing screws p

Classic models : The control knob is located on thelower right hand side of the outer case.It is marked asshown in figure 6;Linear models : The contro

Please note that the Linear and Classic models aresupplied with a tinted glass facia assembly, which dif-fer in appearance when viewed from the front,