Smeg LSA643BPQ Manual do Utilizador descarregar pdf (Página 14)

User instructions

TO CHANGE A PROGRAM

To change the running program it is necessary:

• to interrupt the running program (see “INTERRUPTING A PROGRAM”);

• select the new program;

• to press again the START/STOP button (7) to make start the new

program.

STOPPING A PROGRAM

To stop a program in progress, it must first be interrupted (see

NTERRUPTING A PROGRAM").

Now press buttons P1+P2 simultaneously and

the first three program lights will come on.

The display will show "P0" and the dishwasher will immediately switch to

the end of the cycle and drain the tank (during this process, the "Time to

end" message will flash). When the drain procedure ends, the end of

cycle message "End" appears on the display.

In case that the door is opened during the operation, to the next door

closing it is going to be necessary to start the program as shown in

paragraph “START PROGRAM”. The program will resume from the point in

which it was interrupted.

In case that the tub temperature is higher than 50°C the program

will start about 30 seconds later.

The washing cycle will not take place if the dishwasher door is left open or

not properly closed.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Sem comentários

Smeg LSA643BPQ Manual do Utilizador Página 14