Smeg P23LINP Guia de Resolução de Problemas

INSTALLATION & USER INSTRUCTIONSAll instructions must be handed to the user forsafekeeping.MODELS COVERED BY THESE INSTRUCTIONSP23 LINEAR - P23LIN

It is recommended that the catalysts are inspected for signs of damage and dirt during routine servicing procedures. The expect-ed life of the catalys

Fire sparks but pilot does not light No gas to fire, check isolators are open.Pipe work blockage, clean out.Air not fully purged, re purge supply or w

• The installation and Servicing of this fire MUST only be carried out by a competent person in accordance with local Codesand/or Regulations, Buildin

Clearances to combustible materialsCombustible materials are defined as wood, fabrics, or other materials likely to combust if exposed to flame. Gener

Classic models : The control knob is located on thelower right hand side of the outer case. It is marked asshown in figure 2;Linear models : The contr

The appliance should be checked on an annual basis to ensure it is working safely and that there is no excessive build up of soot.The frequency of ser

• This appliance is a high efficiency, flueless catalytic flame effect gas fire. It provides radiant and convected warmth both effi-ciently and safely

DestinationCountryCatInlet Pressure(mbar)Max Energy Input(kW)Min Energy Input(kW)High BurnerPressure(±1.5 mbar)Low BurnerPressure(±0.75 mbar)G20 G25Gr

This appliance may be installed in any room in the home except bathrooms. If the appli-ance is to be fitted in a bedroom then an electronic carbon mon

Remove the outer packaging, remove any instructions or fixing kits. Read ALL these instructions before continuing to unpack orinstall this appliance.

If the appliance is to be mounted on a dry lined wall ora timber framed construction wall then efforts shouldbe made to fix in at least two positions

Classic models : The control knob is located on thelower right hand side of the outer case. It is marked asshown in figure 7;Linear models : The contr

Please note that the Linear and Classic models aresupplied with a tinted glass facia assembly, which dif-fer in appearance when viewed from the front,

All models : Firstly, remove the decorativeframe/glass facia assembly as described in section8.3. Remove the inner glass panel, and disconnectthe gas