Smeg CIR60X3 Manual de Instruções

Index 1. INSTRUCTIONS FOR SAFE AND PROPER USE________________ 4 2. POSITIONING OF HOB ____________________________________ 6 3. GAS CONNECTION____

Instructions for the installer 12 4. ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on

Instructions for the installer 5. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the applianc

Instructions for the installer 14 5.2 Regulation for LPG Loosen screw A and push support B all the way. Use a double head wrench to remove nozzle C

Instructions for the installer 5.3 Regulation for natural gas The hob has been adjusted for natural gas at a pressure of 1.0kPa. To allow the unit

Instructions for the installer 16 6. FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards, the

Instructions for the installer 6.3 Arrangement of burners on hob BURNERS 1 Auxiliary 2 Semi-rapid 3 Rapid 4 Rapid 5 WOK 6.4 Lubrifica

Instructions for the user 18 7. USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted

Instructions for the user 7.2 Practical advice for using the burners For better burner performance and minimum gas consumption, flat bottomed, even

Instructions for the user 20 7.4.2 Using the electric elements The electric elements are ideal for ultrarapid cooking. The settings shown in the ta

Instructions for the user 8. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 8.1 Cleaning C

Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY

Instructions for the user 22 8.2 Cleaning of cooking hob components CAUTION: do not wash these components in a dishwasher. In normal use of the hob,

Instructions for the user 8.3 Preventive maintenance This appliance does not need any special maintenance. However, a few simple operations have to

Instructions for the user 24 9. PROBLEMS AND CAUSES Each of the following cases is caused by an abnormal operation of the appliance and should be

914773400/ B

Introduction THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING

Instructions for the installer 6 2. POSITIONING OF HOB It is the law that all gas appliances are installed by authorised persons. Clearance arou

Instructions for the installer In case of installation on a hollow compartment with doors, a separating panel has to be placed under the hob. Kee

Instructions for the installer 8 2.2 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances –

Instructions for the installer Where B, measured from the periphery of the nearest burner to any vertical combustible surface, is less than 200 mm,

Instructions for the installer 10 2.3 Room ventilation Caution – This hob may only be installed and operated in rooms permanently ventilated in ac

Instructions for the installer 3. GAS CONNECTION This appliance is suitable for installation with Natural Gas or LPG (propane). Refer to page 12 f