Smeg TLS12 Instruções de Utilização Página 12
- Página / 21
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
GB 10
CARE AND MAINTENANCE
Detergent dispenser
Clean the detergent dispenser regularly, at least three or
four times a year, to prevent detergent build-up:
1.
Push in the buttons on each side of the dispenser.
2.
Pull the dispenser towards you and remove it.
A small quantity of water can remain in the dispenser. It is
advisable to carry the dispenser in an upright position.
3.
Wash the dispenser using running water.
You can also remove the siphon caps in the dispenser for cleaning.
4.
Replace the siphon caps in the dispenser (if removed).
Make sure that they lock in place.
5.
Replace the dispenser by locating the bottom tabs in the lid
holes and pivot until both of the upper buttons lock.
Note: ensure that the detergent dispenser is correctly
reinstalled.
Water inlet hose filter
Check and clean regularly (at least two or three times a year).
1.
Unplug the washing machine.
2.
Turn off the tap.
3.
Unscrew the hose from the tap.
4.
Carefully clean the filter located at the end of hose, without
disassembling it, for example with a tooth-brush.
Note
: Do not submerge the hose in water.
5.
Screw the flexible hose back onto the tap by hand. Do not use
pliers (risk of squashing the joint).
6.Turn on the tap and check that the connections are
water-tight.
7.
Plug the washing machine back in.
Water inlet hose
Check the inlet hose regularly for brittleness and cracks and
replace it if necessary using a new hose of the same type.
The inlet hose as shown on picture “
A
” has a safety valve to
prevent the appliance against uncontrolled water inlet; if the
safety valve inspection window is red, the safety valve has been
activated and the hose must be exchanged. Contact out After-
Sales Service or your specialist dealer to obtain a new inlet hose.
If your inlet hose has a transparent hose coating (fig. “
B
”),
periodically check the colour of the transparent coating. If the
coating begins to turn red, this is an indication that the hose may
have a leak and should be replaced. Contact our After-Sales
Service team or specialist dealer to obtain a replacement hose.
B
A
Safety valve
inspection
window
IFU-TL HR GB.fm Page 10 Thursday, February 15, 2007 3:35 PM
Black process 45.0° 100.0 LPI
- CONTENTS 1
- GB TLS 12 2
- 5019 612 10134 2
- PROGRAMME CHART 2
- PRECAUTIONS AND GENERAL 5
- RECOMMENDATIONS 5
- BEFORE THE FIRST WASH CYCLE 6
- PREPARATION OF THE WASHING 7
- Loading the laundry 8
- DETERGENTS AND ADDITIVES 9
- Using chlorine bleach 10
- Using starch powder 10
- CLEANING THE FILTER/ 11
- DRAINING RESIDUAL WATER 11
- CARE AND MAINTENANCE 12
- TROUBLESHOOTING GUIDE 14
- AFTER-SALES SERVICE 17
- TRANSPORT AND HANDLING 17
- INSTALLATION 18
- Adjust the feet 19
- Connect the water inlet hose 19
- Connect the water drain hose 20
- ELECTRICAL CONNECTION 21
Manuais e produtos relacionados com Máquinas de lavar roupa Smeg TLS12
(34 páginas)
Máquinas de lavar roupa Smeg LBS645-5 Manual
(12 páginas)
(12 páginas)
(30 páginas)
(26 páginas)Streetglow Neon Shift Knob Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Beleuchtung Streetglow Neon Shift Knob.
Wir stellen 1 PDF-Handbücher Streetglow Neon Shift Knob zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Comentários a estes Manuais