Smeg SW Range Manual de Instruções

SW ... RUK Instructions for use DE Bedienungsanleitung FR Mode d’emploi NL Gebruiksaanwijzing ES Instrucciones para el uso

10GBGlass shelvesThe shelves are made of tempered glass and can be repositioned within the cabinet. To move the shelves, the door must be opened 90°.

11GBAutomatic defrostingThe refrigerator is defrosted automatically. Defrost water runs through a pipe and is collected in a tray above the compressor

12GBFault ndingFault Possible cause RemedyNo control lamps are lit.The appliance is switched off.Power failure; the fuse is blown; the appliance is n

13GBSpare partsWhen ordering spare parts, please state the type, serial and production numbers of your appliance (see g. 1 on page 3 and g. 17). Thi

14GBEnvironmental regulations on disposal must also be observed. When disposing of the appliance you should contact your local authority technical dep

2GBThank you for purchasing your new refrigerator from Smeg. Please note that these instructions apply to all refrigerators in the SW range. Illustrat

3GBGet to know your refrigeratorControl panelLightingBottle rackNameplateShelf with storage boxesDoor shelfGlass shelfSealing stripDoor handleCrisper

4GB600600600600600600600600g. 2g. 3PlacementFor safety and operational reasons, the appliance must not be installed outdoors.The appliance should be

5GB1650/19501001001560/1860g. 6g. 7600 610 g. 4VentilationIt is important that the appliance be well ventilated and that air can circulate unhinder

6GBSetting upIt is important that the appliance be absolutely level. To level the appliance, remove the kick plate below the door and screw the adjust

7GBReversing the doorThe door can be changed from right-hinged to left-hinged and vice versa as follows:1. Lay the appliance on its back with the

8GBThe appliance is intended for connection to alternating current. The required volt-age (V) and frequency (Hz) are stated on the nameplate inside th

9GBThe thermostat button can be set from 1 (less cold) to 7 (more cold). A suitable setting must be found by trial and error. Start by setting the but