Smeg PDXF116RS Manual de Serviço

21Table of ContentsINSTRUCTIONS FOR THE USER: these provide recommendations foruse, a description of the controls and the correct procedures for clean

30Instructions for the Installer8.1.2 Installation to a flush mounting structureMake a hole in the top of the cabinet of the size shown in the figure,

31Instructions for the InstallerThis type of appliance also requires a cut 3 mm deep in the top with thedimensions shown in figure 7 (detail A). Befor

32Instructions for the Installer8.2 Securing the appliance to the cabinet8.2.1 Securing the side bracketsFit the two provided brackets to the short si

33Instructions for the Installer8.3 Electrical connectionCheck that the power supply voltage and size are as specified on thenameplate below the appl

34Instructions for the Installer9. GAS CONNECTIONBefore installing, check that the local gas main (type and pressure) andthe appliance's settings

35Instructions for the Installer9.2 Room ventilationThe appliance may only be installed in a permanently ventilated room asspecified by the relevant r

36Instructions for the Installer10. ADAPTING TO DIFFERENT TYPES OF GASBefore carrying out the operations described below, disconnect theappliance from

37Instructions for the Installer10.2 Burner and Nozzle Data TablesBurnerRATED HEAT CAPACITY (KW)LPG – G30/G31 28/37 mbarNozzle diameter1/100 mmBy-pass

38Instructions for the Installer11. FINAL OPERATIONS FOR GAS APPLIANCES After making the adjustments described above, reassemble the appliance,reversi

22Precautions for Use1. PRECAUTIONS FOR USETHIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. TAKE GOOD CAREOF IT AND KEEP IT TO HAND THROUGHOUT THE HO

23Disposal instructions2. DISPOSAL INSTRUCTIONS - OURENVIRONMENT POLICYOur products are only packaged using non-pollutant, environment-friendly,recycl

24Safety Precautions3. SAFETY PRECAUTIONSSEE INSTALLATION INSTRUCTIONS FOR SAFETY REGULATIONS FORELECTRIC OR GAS APPLIANCES AND FOR VENTILATION FUNCTI

25Instructions for the User4. GETTING TO KNOW YOUR APPLIANCE5. BEFORE INSTALLATIONAuxiliary Burner (AUX) Rapid Burner (R)Semi-rapid (SR) burner Ultrar

26Instructions for the User6. USING THE HOB6.1 Gas hobBefore lighting the hob burners check that the flame diffuser rings arecorrectly in place with t

27Instructions for the User6.2 Practical hints for using the burnersFor better burner efficiency and to minimise gas consumption, use panswith flat, e

28Instructions for the User7. CLEANING AND MAINTENANCENEVER USE A JET OF STEAM FOR CLEANING THE APPLIANCE.Before carrying out any operations, disconn

29Instructions for the Installer8. FITTING THE APPLIANCE8.1 Fitting the appliance in the topThis appliance is in class 3. The procedures required belo